3D-printed decorative bust
Manufacturer
Martin Benko – ArtDesignMC
Rifer Hauptstraße 142
5400 Hallein
Austria
Email: artdesignmc@icloud.com
Phone: +43 660 1570128
Intended use
This product is intended exclusively as a decorative object: PLA versions for indoor use, PETG versions for indoor use and sheltered (covered) outdoor areas. It is not a toy and is not suitable for use by children.
Warnings
Caution – risk of injury from sharp edges and points!
Due to the manufacturing process, some areas of the bust may have sharp edges, points or rough surfaces. Handle with care to avoid cuts and puncture injuries.
Caution – not a toy!
This product is intended for decorative purposes only and is not suitable for play. Keep out of the reach of children.
Caution – risk of breakage and injury!
If dropped or handled improperly, the product may be damaged or break. This can produce sharp-edged fragments and small parts. Do not continue to use damaged products and dispose of fragments safely and immediately.
Safe use
- Only place the bust on a level, stable surface with sufficient load capacity so that it cannot fall or tip over.
- Do not throw or drop the product or subject it to strong mechanical stress.
- Do not put in the mouth. Broken-off small parts must not be swallowed.
- Do not use as a utensil, toy or for storing food.
- Check the bust regularly for damage and loose parts.
- Protect the product from excessive heat, direct sunlight behind glass (e.g. windowsill, conservatory, car) and open flames. PLA can deform from approx. 55–60 °C.
Note on the manufacturing process
Due to the 3D printing process, production-related surface textures and minor irregularities may occur. These may be visible or noticeable to the touch, especially on fine details, edges and protruding elements.